Their ends have a threaded opening in them that accept the smaller chassis screws. Standoffs – these are screws that are used to hold the motherboard about 1/8″ from the motherboard mounting plate.Smaller screws – just like the chassis screws, just with a smaller diameter.Chassis screws – this is the type used to tighten down cards, etc.These are usually held in a small plastic bag nestled inside the case. Now is a good time to go through the screw supply provided with the case. Not all of this may be necessary on your case, and if you’re using a case you already had, much or all it has likely been done already. Go through the following checklist to make sure it is prepared. Before you can use it for a new system, you must prepare it for use. Now that this is done, you are ready to move on.Īt this point, you should have the new case in front of you with the cover removed. You don’t want to force it and break anything – take your time. Whatever case style you have, remember to look it all over before you attempt to gain entry. This is convenient for making quick changes to the system, although you still have to disconnect the various cables to get it out all the way. With others, you can remove the whole motherboard mounting plate and card rack combo from the case by sliding it out the back. You may find some where you don’t even have to remove the front, and rather you just slide the sides off. There are almost as many designs as there are companies that make them. Other cases come apart in a similar way, but after you take the front off, the top and sides come off together.Įach case is a little different in how it comes apart. Your case, in essence, comes apart in four pieces. The sides then lift and slide off as does the top. These cases are usually pretty durable so you really don’t have to worry about hurting them. It is my experience that this usually requires a few tries and some muscle. With this design, you usually take hold of the bottom of the front bezel of the case and give it a nice solid yank. These cases are designed such that you can remove the cover simply by un-latching the parts from the chassis. Some manufacturers have developed cases using a “screwless” design. Still other cases come apart differently. Simply twist them loose using your fingers. It works the same way, obviously, except that you do not need to use a screwdriver to loosen and remove them. Some cases use thumb screws rather than standard screws. Only the top and sides come off as a single cover.
With this design, the front of the case (also known as the bezel) does not move. Once they are removed, the entire case cover comes off in one piece. Hang on to these screws and put them in a place where they will not be scattered and can be easily found later in this procedure. If you have a standard case, you take a screwdriver and remove the four or six screws located around the edge on the back of your case.
#How to make your mouse smaller install#
Leave your hardware in these bags until you are ready to install them. Most electrically sensitive hardware comes in a static bag which is designed to protect the electronics from static electricity shock. To build a basic PC, you will need at least a motherboard, a memory module, a processor with heatsink/fan, a power supply, a hard drive and a DVD drive. Video Card (optional if motherboard/CPU has onboard video).Memory Modules (recommend dual channel, triple channel, or quad channel kits, depending on the motherboard capabilities).DVD Drive (recommended is a burner, because they are only about $20 advanced users can install an OS from a flash drive).Magnifying Glass - Use with the flashlight to inspect the CPU and socket, and anything else that concerns you.
#How to make your mouse smaller Pc#